Technicolor TD5130 User Manual

Maintenance
7.3 Remote Access
This page allows you to create and edit remote access rules. You can specify the IP
address or the subnet mask of devices that are allowed or denied to remotely access
your Wireless Gateway and set the type of management service that they can access.
To access the Remote Access page, click MAINTENANCE > Remote Accesss.
The table lists the remote access rules. To edit an entry, click the corresponding
icon. To delete an entry, click the corresponding icon.
To create remote access rules, click the Add button.
Wan Interface — Select the interface from the drop-down list.
Status — Select whether to enable or disable remote access of the device.
Remote IP — Enter the IP address of the remote device.
Remote IP Mask — Enter the IP mask of the remote device.
Service — Select the type of remote management service that the device can or
cannot access.
Click the Apply button to save your changes or click the Cancel button to discard your
changes.
Wireless ADSL2+ Gateway 87

Technicolor TD5130 Specifications

General

Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
ADSL Standards	ANSI T1.413 Issue 2
ADSL2 Standards	ITU G.992.3 (G.dmt.bis) Annex A
ADSL2+ Standards	ITU G.992.5 Annex A
Wireless	802.11b/g
Ethernet Ports	4 x 10/100
USB Ports	1 x USB 2.0
VoIP	No
Security	WEP, WPA, WPA2