Advanced
The table lists the existing filter rules. To edit an entry, click the corresponding
icon. To delete an entry, click the corresponding button.
To add a filter, click the Add button. The IP Filter Config screen is displayed.
IP Filter — Check this box to enable IP filtering.
Filter Name — Enter a filter rule name.
Start Source IP Address — Enter the starting point of the source IP address.
End Source IP Address — Enter the ending point of the source IP address.
Source Port — Enter the source port number.
Start Destination IP Address — Enter the starting point of the destination IP address.
End Destination IP Address — Enter the ending point of the destination IP address.
Destination Port — Enter the destination port number.
Protocol Type — Select the protocol from the drop-down list.
Time Schedule — Select the time to implement the IP filter or click the New Time
Schedule button to create a new schedule.
Click the Apply button to save and activate the filter or click the Cancel button to
discard your changes.
Wireless ADSL2+ Gateway 62
To Next Page
Loading...
Need help?
General
