Advanced
Filter Name — Select the filter to assign the rule.
Enable — Check this box to enable this rule.
Ether Type — Select the Ether type: IP (0x800) or IPv6 (0x86DD).
Protocol — Select a protocol from the drop-down list. Options are TCP, UDP, or ICMP.
Action — Select the action to execute when the rule requirement is met. Options are:
• Drop: Select to drop the packets if the rule requirement is met.
• Permit: Select to allow packets to pass through if the rule requirement is
met.
• Reject: Select to reject the packets if the rule requirement is met. Select the
Reject Type from the drop-down list.
Depending on the selected protocol and the selected action, the fields below may or
may not be displayed on the screen.
Origin IP Address — Enter the IP address of the origin of the packets.
Origin Mask — Enter the subnet mask of the origin of the packets.
Origin Start Port and Origin End Port — Enter the starting and ending port range of
the origin of the packets.
Destination IP Address — Enter the IP address of the destination of the packets.
Destination Mask — Enter the subnet mask of the destination of the packets.
Destination Start Port and Destination End Port — Enter the starting and ending port
range of the destination of the packets.
ICMP Type — Select an ICMP type from the drop-down list. If the selected type is met,
the filter is implemented.
Click the Apply button to save and activate the rule or click the Cancel button to
discard your changes.
Wireless ADSL2+ Gateway 68
To Next Page
Loading...
Need help?
General
