32
3 Configuration tools
DMS3-CTC-25-282 v1.0
3.1.3 Protecting access to the TG789vac v2
Introduction
To prevent that every user on your local network can access the TG789vac v2, the TG789vac v2 is secured with a user name
and password.
Protected items
The user name and password is used to secure access to:
• The TG789vac v2 GUI.
• The embedded FTP Server.
for more information, see “7.3 The TG789vac v2 FTP server” on page 63.
Default user name
The default user name is Administrator.
Default password
The default password is either blank or the ACCESS KEY printed on the label of your TG789vac v2. This depends on the
settings chosen by your Service Provider.
How to change your password
Proceed as follows:
1 On the Toolbox menu, click User Management.
2 In the Pick a task list, click Change my password.
3 Enter your new password and click OK.
4 Your new password is now active. The next time that you log on to the TG789vac v2 GUI you will have to enter this
password.
It is recommended to change the default password settings.
Choose a password that your can easily remember or write it down. If you forget your password the only option is to
reset your TG789vac v2. For more information, see “10.6 Reset to factory defaults” on page 98.
This password will also be used by the network file server and FTP server.
For more information about the network file server and FTP server, see “7 Sharing content” on page 54
To Next Page
Loading...
