18
2Setup
DMS3-CTC-25-282 v1.0
2.1.2 Setting up your TG789vac v2 as local router
Procedure
Proceed as follows:
1 Take an Ethernet cable. If your box contains an Ethernet cable with red connectors, you can use that cable.
2 Plug one end of the cable in the red WAN port on the back of your TG789vac v2.
3 Plug the other end of the cable into the Ethernet port of your Internet gateway/modem.
The WAN port can only be used to connect your TG789vac v2 to an Internet gateway/modem. You can not use it to
connect other devices (for example, a computer) to the TG789vac v2.
To Next Page
Loading...
