Technicolor TG789vac v2 - Configuring the Upnp AV Media Server

60
7 Sharing content
DMS3-CTC-25-282 v1.0
7.2.1 Configuring the UPnP AV media server
Introduction
This section helps you to set up the TG789vac v2 UPnP AV media server
Enabling/disabling the UPnP AV media server
Proceed as follows:
1 Browse to the TG789vac v2 GUI.
For more information, see “Accessing the TG789vac v2 GUI” on page 29.
2 On the Toolbox menu, click Content Sharing.
3 In the Navigation bar, click Configure.
4 Under UPnP AV Media Server, click Server Enabled.
5 Click Apply.
Media database
When you plug in your USB storage device, the TG789vac v2 will automatically start building the media database. This
database lists all meta data that is embedded the your media files stored on your USB storage device.
To view the status of the media database:
1 Browse to the TG789vac v2 GUI.
For more information, see “Accessing the TG789vac v2 GUI” on page 29.
2 On the Toolbox menu, click Content Sharing.
3 In the Navigation bar, click Configure.
4 Under UPnP AV Media Server, you can find the Database Status.
5 If you want to rebuild the database, click Rebuild.