Technicolor TG789vac v2 - Configuring WPA-PSK Encryption

42
4 Wireless networking
DMS3-CTC-25-282 v1.0
4.4.2 Configuring WPA-PSK encryption
Procedure
Proceed as follows:
1 Browse to the TG789vac v2 GUI.
For more information, see “Accessing the TG789vac v2 GUI” on page 29.
2 On the left menu, click Home Network.
3 The Home Network page appears, Under Wireless. click:
 WLAN to view the settings of the 2.4 GHz access point.
 WLAN_5G to view the settings of the 5 GHz access point.
4 The Wireless Access Point page appears. In the upper-right corner, click Configure.
5 In the Security Mode list, select one of the following modes:
 WPA-PSK
 WPA2-PSK
 WPA-PSK + WPA2-PSK
For more information, see “Encryption types” on page 40.
6 In the WPA-PSK Encryption Key box, type a the key of your choice. The key must be in one of the following formats:
 8 to 63 alphanumeric characters. For example: MyKey123
 8 to 64 hexadecimal characters (characters from 0 to 9 and from A to F). For example: C54F48A5.
7 Click Apply.
8 Reconnect your wireless client(s) to the TG789vac v2 using these new security settings.
For more information, see “4.1 Connecting your wireless client via WPS” on page 36 or “4.2 Connecting your wireless client
without WPS” on page 38.