7.7 Return to last set channel
> The last set channel is reset by pressing the Return key on the remote control.
> The previously seen channel is set by renewed pressing of the key.
7.8 Display timer and channel info
This function enables the channel information of the current channel to be displayed.
> Press the key Info to display the information regarding the current channel.
An insert now appears in the lower half of the picture with the current time, the name of the
set channel and the current broadcast with beginning and stop times, if the required data has
been transmitted by the station. Info on the appliance once, extended information onm the
current channel will be shown on the screen or the display.
7.9 Further channel information
If broadcast, the function channel info will allow you to receive additional information on the
channel currently switched on.
> Pressing the key Info of the remote control twice or by pressing the key
> More in-depth texts can be moved temporarily with the up/down arrow keys of
the remote control or the up/down channel keys.
> The following channel is displayed, if transmitted, by pressing the Info key again.
> The insert disappears by pressing the Info key again.
7.10 Transponder iInfo
> By pressing the green function key (Transponder Info), will display the data of the set
transponder.
> The coloured function keys enable you to additionally display Audio/Video informa-
tion, channel information and also information on the used encoding system
(CA).
> Exit Info with the Menu key.
7.11 Freeze frame
> The current TV picture is displayed as a freeze image by pressing the Stop/Freeze
image key.
> Pressing this key again returns you to normal operation.
7.12 Sleep timer
> By pressing the key several times, Sleep-Timer sets the switch-off time of the recei-
vers to between 15 minutes and 2 hours. The receiver goes to standby automatically
after the set time has expired.
24
To Next Page
Loading...
Need help?
General
