> Select the Save field with the arrow keys up/down.
> Now rotate the dish with the right arrow key (Field East is highlighted or left field
West is highlighted) to the required position. Hold down the relevant key until the
required position has been reached.
As soon as the dish has completed the rotation, the receiver will check the orbital position
automatically and display it in the lower part of the menu, if it can be determined.
9.3.2.3 Automatic fine alignment (Auto focus)
Before saving the satellite position, you should carry out automatic focussing. Here, the dish
is set to the optimal technical reception.
> Press the blue function key Action, to open the window with the available activities.
> Select the Auto focus line with the arrow keys up/down.
> Pressing OK will start Auto focus. While the automatic alignment is carried out, the
message “please wait” is displayed.
9.3.3 Save satellite position
Select the channel that you would like to add to the list with the arrow keys up/down.
> Select the channel that you would like to add to the list with the arrow keys
up/down.
> Press the key OK. The message. is displayed, if the orbital position to which the dish
is aligned corresponds to the orbital position of the to be stored satellite
> A query. is displayed, if the orbital position could not yet be determined.
> In order to save the satellite position, use the right/left arrow keys to highlight the
field yes and confirm with OK. A message is displayed, if no position stored by pre-
programming is recognised during the examination of the test transponder or if the
reception signal is too weak.
> In order to save the satellite position, use the right/left arrow keys to highlight the
field yes and confirm with OK.
9.4 Current satellite list
The satellite positions are saved in the satellite list. Not yet stored positions are marked in
this list with a “*”.
> To rotate the dish to a position stored in the satellite list, select the Current satelli-
te list. field with the arrow keys.
> Press the OK key.
> Select the required position with the arrow keys up/down.
> Confirm with OK, in order to turn the dish to the required position. During the swivel-
ling process, the message “rotating” flashes on the screen.
9.4.1 Select satellite position
To rotate the dish to the position set in the satellite list, zour digital receiver is equipped with
the Rotate to satellite function.
51
To Next Page
Loading...
Need help?
General
