Note:
The digital receiver must be in the standby mode to automatically downlo-
ad the new software.. This procedure may not be interrupted e.g. by tur-
ning the device on or off.
Irrespective, of whether you have turned the automatic software update function on or off,
the device automatically checks when it is turned on, whether a new system software is avai-
lable for your digital receiver. Available new system software is indicated by a message on
the screen.
To update the software, follow the instructions on the screen.
8.5.5 Copying the settings
You have the option to copy all settings, such as programme list, anrenna settings, etc. of
your digital receiver (transmitter) to another digital receiver (receiver) of the same type and
same version of the operating software.
> For this purpose connect both devices with the zero modem cable.
> Turn the (receiving) receiver on.
> Press any key of the (receiving) receiver to copy the settings. The settings of the
transmitting receiver are now transferred to the receiving receiver. Please observe the
screen inserts.
8.6 System configuration
You can view of the specific device data (such as e.g. the current software version) in this
menu option.
> Highlight this line in the sub-menu Settings with the up/down arrow keys.
> Confirm with OK.
> Pressing the Menu key returns you to normal operation
8.7 Encoding system
From this menu item, you will arrive at the sub-menus of the inserted CONAX or. CRYPTO-
WORKS smart card and the CA-module. By selecting the smart card or the CI-slot with the
arrow keys and confirming with OK you can import the information on the smart card or
used CA module.
Manual initialisation of the CA module
> By pressing the green function keyb CI Reset, you can initialise the CI module
manually.
9 Operating a rotational unit (DiSEqC 1.2)
Your digital receiver has been prepared for operation on a rotational unit. With the help of the
DiSEqC controller (DiSEqC Level 1.2), you have the possibility to control a compatible motor
via the coaxial ransmission line.
> As described in Section 6.4, call up the menu Antenna Settings and activate the
DiSEqC controller (Section 6.4.1).
> With the help of the up/down arrow keys select the DiSEqC position (e.g. A/B 3),
to which you would like to allocate the motor antenna.
46
To Next Page
Loading...
Need help?
General
