Source
> Select the Source column with the arrow keys.
> Press the key OK.
> In the pop-uo window, which is now open, select the required source using the
up/down arrow keys (TV or radio).
> Confirm with OK. Now, depending on the previously carried out setting, the TV-chan-
nel or the radio station list will be displayed.
> You can now select the required channel with the arrow keys up/down.
> Using the arrow keys up/down you can move the marker through the list by one
line at a time.
> The arrow keys left/right enable scrolling through the list page-wise upwards or
downwards.
> This is stored in the timer by pressing the OK key.
Date
> Select the Date column with the arrow keys.
> Enter the date (4-digit) by means of the numeric keyboard, at which the timere-
vent is to take place.
Start
> Select the Start column with the arrow keys.
> With the help of the numerical keyboard use this line to enter the statring time for
the Timer.
Stop
> Repeat the steps as described in “Start” in order to enter the time to stop recording
(except for Timer for channel change).
Repeat
> Select by means of the arrow keys the Repeat column.
> Press the key OK. A pop/up window will appear, displaying various suggestions for
repetitions.
1x Timer on once
T Daily repetition
1 W Repetition once a week
1-5 Repetition only on workdays
6-7 Repetition only on the weekend
> Select the required function with the arrow keys up/down.
> The setting is taken over by pressing the OK key.
Storing the data in the memory
> After having completed the programming process, press the yellow control key
Accept in order to store the data.If you have selected a channel under Channels
which is blocked acording to Section 8.3 you must first enter the PIN number before
31
To Next Page
Loading...
Need help?
General
