Technogym KINESIS ONE - Check the Cables; Check the Cross Limit Switch; Checking Various Rubber Parts

KINESIS ONE: Service & Maintenance Manual rev. 2.1
Page 8.3
8.1.4. CHECK THE CABLES
1. Check the wear status of the machine cables, paying special attention to any hardened spots or
cracks in the protective plastic of the cable. Replace any worn parts.
2. Check the passage of the machine cables through pulleys and/or the terminals connected to
handles.
3. Check the tension of the machine cables.
8.1.5. CHECK THE CROSS LIMIT SWITCH
1. Check the wear status of the cross limit switch. Repair and/or replace any worn parts.
2. Check the position of the cross limit switches and make sure they are firmly fastened in place.
8.1.6. CHECKING VARIOUS RUBBER PARTS
These operations apply to handles, frame guards, feet …
1. Check the wear status of the rubber parts used on the machine. Repair and/or replace any worn
parts.