ELEMENT LINE: Service & Maintenance Manual - rev. 1.2
Page 7.3
7.3. LOCKING DOWN THE DOWELS ON THE ARM
EXTENSION LEVER
Each lever of the Arm Extension machine has a joint consisting of 2 threaded ends and one with an
intermediate steel cable. This must be fixed without excessive force, to avoid over-tightening and
damaging the steel cable. Therefore, lock down until the end of the thread, and then use the 3 dowel
screws circled in the figure below to secure the components in place.
Figure 7.3-1
Use a torque wrench to check that they are locked down with the prescribed torque of 13 Nm / 9.6
ft.lbs.
To Next Page
Loading...
