Miscellaneous commands
Miscellaneous co
mmands are those commands that perform such functions as saving
calibration constants, locking out calibration, and programming date parameters.
:CODE
(:CALibration:PROTected:CODE)
Purpose
Format
Parameters
Description
To unlock calibration so the calibration procedures can be performed.
:
cal:prot:code '<password>'
Up to an 8-character string including letters and numbers.
The :CODE command sends the password and enables calibration when
performing these procedures via remote. The correct password must be sent
to the unit before sending any other calibration command. The default
remote password is KI002410.
Note
• The
:CODE command should be sent only once before performing
calibration. Do not send :CODE before each calibration step.
• To change the code, first send the present code, and then send the new
code.
• The password parameter must be enclosed in single quotes.
• If you change the first two characters of the password to something other
than "KI," you will not be able to unlock calibration from the front panel.
Example :CAL:PROT:CODE 'KI002410' Send default code of KI002410.
:COUNT?
(:CALibration:PROTected:COUNT?)
Purpose To request the number of times the Model 2410 has been calibrated.
Format :cal:prot:count?
Response Number of times calibrated.
Description The :COUNT? query can be used to determine the total number of times the
Model 2410 has been calibrated.
Example :CAL:PROT:COUNT? Request calibration count.
Command Reference B-3
2410-902-01.book Page 3 Monday, November 7, 2005 2:49 PM
To Next Page
Loading...
Need help?
General
