Introduction
Use the procedures in this section to calibrate the Model 2410. These procedures require
accurate test equipmen
t to measure precise DC voltages and currents. Calibration can be
performed either from the front panel, or by sending SCPI calibration commands over the
IEEE-488 bus or RS-232 port with the aid of a computer.
WARNING The information in this section is intended for qualified service personnel
only. Do not attempt these procedures unless you are qualified to do so.
Some of these procedures may expose you to hazardous voltages.
2-2 Calibration
2410-902-01.book Page 2 Monday, November 7, 2005 2:49 PM
To Next Page
Loading...
Need help?
General
