Front panel disassembly
Use the following steps to remove the display board and/or the pushbutton switch pad.
1. Unplug the display board ribbon cable.
2. Remove the front panel assembly.
This assembly has four retaining clips that snap
onto the chassis over four pem nut studs.
Two retaining clips are located on each side of the front panel. Pull the retaining clips
outward and, at the same time, pull the front panel assembly forward until it separates
from the chassis.
3. Using a thin-bladed screw driver, pry the plastic PC board stop (located at the bottom of
th
e display board) until the bar separates from the casing. Pull the display board from the
front panel.
4.
Remove the switch pad by pulling it from the front panel.
5-8 Disassembly
2410-902-01.book Page 8 Monday, November 7, 2005 2:49 PM
To Next Page
Loading...
Need help?
General
