Introduction
This section explains how to handle, clean, and disassemble the Model 2410. Disassembly
drawings are located at the end of this section.
Handling and cleaning
To avoid contaminating PC board traces with body oil or other foreign matter, avoid touching
the PC board traces while you are repairing the instrument. Motherboard areas covered by the
shield have high-impedance devices or sensitive circuitry where contamination could cause
degraded performance.
Handling PC boards
Observe the following precautions when handling PC boards:
• Wear cotton gloves.
• Only handle PC boards by the edges and shields.
• Do not touch any board traces or components not associated with repair.
• Do not touch areas adjacent to electrical contacts.
• Use dry nitrogen gas to clean dust off PC boards.
Solder repairs
Observe the following precautions when you must solder a circuit board:
• Use an OA-based (organic activated) flux, and take care not to spread the flux to other
areas o
f
the circuit board.
• Remove the flux from the work area when you have finished the repair by using pur
e
water with
clean
, foam-tipped swabs or a clean, soft brush.
• Once you have removed the flux, swab only the repair area with methanol, then blow-
dr
y t
he board with dry nitrogen gas.
•
After cleaning, allow the board to dry in a 50°C, low-humidity environment for several
ho
urs.
5-2 Disassembly
2410-902-01.book Page 2 Monday, November 7, 2005 2:49 PM
To Next Page
Loading...
Need help?
General
