CHAR SET test
The character set test lets you display all characters. Perform the following steps to run the
character set test:
1. Display the MAIN MENU by pressing the MENU key.
2. Select TE
ST, and press ENTER to display the SELF-TEST MENU.
3. Select DISPLAY-TESTS, and press ENTER to display the following menu:
FRONT PANEL TESTS
KEYS DISPLAY-PATTERNS CHAR-SET
4. Select CHAR-SET, and press ENTER to start the character set test. Press any key except
EXIT to cycle through all displayable characters.
5.
When finished, abort the character set test by pressing EXIT. The instrument returns to
the FRONT PANEL TESTS MENU. Continue pressing EXIT to back out of the menu
structure.
4-4 Troubleshooting
2410-902-01.book Page 4 Monday, November 7, 2005 2:49 PM
To Next Page
Loading...
