Reference
QuickMenu
Push the QuickMenu button to see a set of frequently used menu functions on
the display. QuickMenus simplify oscilloscope operation and can increase your
productivit
y.
Scope is a standard QuickMenu for general purpose oscilloscope use. Some
optional ap
plication packages also include a custom QuickMenu display. (See
page 21, Using the Scope QuickMenu.)
Key Points
Using the QuickMenus. To use a QuickMenu, push the screen button that
corresponds to the control you need to set. Push the screen button repeatedly to
choose one of the settings. The small arrow icon indicates that there are additional
setting
s available that are not shown.
You can use most of the front-panel controls at the same time you are using a
QuickM
enu. For example, if you push a c hannel button to select a different
channel, the QuickMenu changes to show information about that channel.
Using Other Menus. You can still use the regular menus. For example, if you push
the Meas button, you can set up and take automatic waveform measurements in
the usual way. If you return to the QuickMenu, the measurement is still displayed
on th
escreen.
Selecting Between QuickMenus. You may have optional application modules
installed that also have QuickMenu displays. To select the QuickMenu you want
to use, push the Menu screen button. This menu item is shown only if application
modules that contain a QuickMenu are installed.
Save/Recall
Push the Save/Recall button to show the save/recall menu.
Bottom Side Description
To File
Saves a setup to a USB flash drive.
Save
Current
Setup
To Setup 1 ...
To Setup 10
Saves a setup to nonvolatile memory.
From File
Recalls a setup from a USB flash drive.
Recall
Saved
Setup
Recall Setup
1 ... Recall
Setup 10
Recalls a setup from nonvolatile
memory.
Recall
Factory
Setup
OK Confirm
Factory Init
Initializes the setup.
84 TDS3000C Series Oscilloscope User Manual
To Next Page
Loading...
