Appendix B: Factory Setup
The n ext table lists the state of the oscilloscope after you recall the Factory Setup.
Control Changed by factory setup to
Acquire horizontal resolution
Normal (10k points)
Acquire mode
Sample
Acquire number of averages
16
Acquire number of envelopes
16
Acquire run/stop
Run
Acquire single sequence
Off
Acquire WaveAlert actions all
Off
Acquire WaveAlert sensitivity
50%
Acquire WaveAlert state
Off
Acquire WaveAlert type
Highlight entire waveform
Channel selection Ch1 (all others off)
Coarse
No change
Confirm delete
No change
Cursor function Off
Cursor H Bar 1 position -3.2 divisions from the center
Cursor H Bar 2 position +3.2 divisions from the center
Cursor H Bar units
Base
Cursor V Bar 1 position 10% of record
Cursor V Bar 2 position 90% of record
Cursor V Bar units Seconds
Cursor tracking
Independent
Delay measure from waveform edge
Rising
Delay measure to edge occurrence First
Delay measure to waveform Ch1
Delay m easure to waveform edge
Rising
Display grati cule type Full
Display backlight High
Display color palette Normal
Display dots only
Off
Display persist time Auto
Dual waveform math function Ch1 + Ch2
Edge trigger coupling
DC
Edge trigger level 0.0 V
Edge trigger slope Rising
Edge trigger source
Ch1
TDS3000C Series Oscilloscope User Manual 131
To Next Page
Loading...
