p
Model 880 DEPOSITION CONTROLLER
y
SECTION 3.XX
e page 134 of 275 ^
To view Control Options...
Screen Key[s] to press
Run Time fixed MENU
MAIN MENU CONTROL OPTIONS <not available>
To view OPT/INF (options / info)...
Screen Key[s] to press
Run Time fixed MENU
MAIN MENU EXECUTIVE MENU
EXECUTIVE MENU OPT/INF
OPT/INF MORE (more pages)
To select ACTIVE FILM (non-sequencing mode only)...
Screen Key[s] to press
Run Time fixed MENU
MAIN MENU NEXT ACTIVE FILM
Numeric entry Digit[s] + ENTER
In SEQUENCING mode, the active film is set by the active process.
.
.films and processes (2.5)
review / edit films (2.5)
film example: see next section (2.7 lead in...)
review / edit processes (2.6)
process example: see next section (2.7 lead in...)
set active process (2.19)
manual power control (2.8)
other run time screen options: crystal, LSQ, SMPL (2.10)
detailed film parameters (2.12)
detailed sys config parameters (2.13 – 2.14)
deposition source control loop desc. (2.15)
shutter delay (2.16)
crystal failure processing (2.17)
process accounting (2.18)
control options/ options inf/ product ID, diagnostics, check sums
power-up sequence
factory/purge parameter tables
product programming summary tables
Sensor card connections
sensor (3.8).
To Next Page
Loading...