EasyManua.ls Logo

Telemark 880 - Safety Warning

Telemark 880
278 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
p
Model 880 DEPOSITION CONTROLLER
y
SECTION 0.XX
e page 2 of 275 ^
Warranty
.
The model 880 Deposition Controller is guaranteed against faulty materials, function, and workmanship for
a period of 12 months after delivery from Telemark. Components which are purchased by Telemark from
other manufactures will be guaranteed for any lesser time that such manufacturer warrants its product to
Telemark. This warranty is valid only for normal use where regular maintenance is performed as instructed.
This warranty shall not apply if repair has been performed or an alteration made by anyone other than an
authorized Telemark representative or if a malfunction occurs through abuse, misuse, negligence, or
accident. No charge will be made for repairs made under warranty at Telemark's facilities. Freight costs
both ways will be at customer's expense. Telemark reserves the right for final warranty adjustment.
User Responsibility
The user is responsible for proper operation an ordinary maintenance of the equipment, following
procedures described in this manual, including reference documents. Proper operation includes timely
replacement of parts that are missing, broken, or plainly worn. If the user has a reasonable doubt about
understanding the use or installation of a component, Telemark Technical Service should be called.
It is vitally important that the user properly install the equipment as described in the Installation sections of
this manual. The warranty will be void if the equipment is improperly installed.
Alteration of the design or any function of the equipment voids the warranty and is entirely the
responsibility of the user.
Safety Warning
General Precautions: Human contact with the voltages present within and around a vacuum system can be
fatal. Make sure that the input power is turned off before opening the doors or removing panels. Short all
HV feedthrough connections with a grounding hook before accessing the controller main body.
Disclosure
The disclosure of this information is to assist owners of Telemark equipment to properly operate and
maintain their equipment, and does not constitute the release of rights hereof. Reproduction of this
information and equipment described herein is prohibited without prior written consent from Telemark.

Table of Contents