Telemark 880 - Ection; Description of Symbols Found in Manual

To Next Page

To Previous Page

Model 880 DEPOSITION CONTROLLER

SECTION 1.XX

e page 4 of 275 ^

Microbalance theory and thickness reading calibration with its attendant density, z factor (a material

reference table of elements is included) and tooling determination. Each section builds on the previous

sections such that no new elements are used that haven't been defined.

.Some sage advice that is

seldom heeded.

SECTION 1.2 DESCRIPTION OF SYMBOLS

.note the following warning/safety/caution symbols [desc. of each].

Please familiarize yourself with the following warning/safety/caution symbols found within this manual

and their general meaning:

Note: Highlights an important fact or condition.

Caution: Warns of a condition that could cause damage to deposition controller, connected or

associated equipment. Also warns if some action taken could result with an undesireable and/or

unexpected outcome.

: Warns of a condition that will likely cause damage to the deposition controller, connected or

associated equipment. Also warns of a possible unsafe situation for the user. Examples are static

sensitivities, maximum component ratings, broken fuses, etc.



: Warns of a condition that is hazardous to user, deposition controller, connected or associated

equipment.

Note

Caution

Static

Sensitive

Hazardous

Voltages

Present

You can lead a customer to water

ut you can't make them read the

manual.

If all else fails

read the manual.