Telemark 880 - Page 212

p Model 880 DEPOSITION CONTROLLER y
SECTION 6.XX
e page 211 of 276 ^
Value Range UNUSED (DISABLED) / INPUT / OUTPUT
Units None
______________________________________________________________________
Parameter 30 I/O Slot 3 Type
access value: REQIO3 Require Input/Output 3 in system, CFGIOS_class
Value Range UNUSED (DISABLED) / INPUT / OUTPUT
Units None
______________________________________________________________________
Parameter 31 I/O Slot 4 Type
access value: REQIO4 Require Input/Output 4 in system, CFGIOS_class
Value Range UNUSED (DISABLED) / INPUT / OUTPUT
Units None
______________________________________________________________________
Parameter 32 Memory Module IFC
access value:
REQMEMMOD Require memory module option installation. Not auto detectable Boolean 1/0 True/False.
Value Range OFF/ON
Units None
______________________________________________________________________
______________________________________________________________________
Read, Write System Parameters Command Examples
Command C10 or C 10
Response A15:33
Description
Read system parameter # 10, system clock time. Result is 15:33 hrs:mins, 3:33 p.m. time.
Command C18
Response A5
Description Read system parameter # 18, NA.
Command D11 = 70689
Response A
Description
Set system parameter 11, calendar date to July 6, 1989. Command received and accepted.
Command D 14= 1
Response A (Possible missed due baud change)
Description Set baud rate 1200 baud.
Table 6.10: Group 3 Examples.
______________________________________________________________________
______________________________________________________________________
Read RunTime Data Group 4 --
Command E
(E) Read RunTime Data. These commands are used for reading back real time numerical information
from Model 880. This includes information such as rate, thickness, power, etc. The group
command is the letter E followed by a parameter number.
Read RunTime Data