Teleste MPH241 - Device Discovery and Management; SNMP and Syslog Configuration

52 MPH200 series video encoders WebUI user manual
Range of multicast IP addresses advertised with SAP. When the stream
multicast address is within the SAP scope, end of the scope is used.
Otherwise default SAP-address 224.2.127.254 is used. Default SAP-
scope is 239.0.0.0 - 239.255.255.255.
_________________________________________________________
This enables ONVIF device discovery feature.
Currently this service is not upported.
Enable/Disable SAP SNMP v2c protocol. Requires licence MLH371
installation. Activation disables ONVIF.
Species the read only community (public or private).
Species the write community (public or private).
Trap Destination denes the IP address of an agent receiving traps.
_________________________________________________________
Syslog is a standard for computer data logging. By using syslog you can
collect messages sent from MPH on the syslog sever.
Shows syslog server IP address. If this eld is left blank then remote
logging is disabled.
_________________________________________________________
This enables RSVP feature (RFC 2205).
Denes RSVP message interval.
RSVP logs
Shows RSVP Logs.
Administrative scope:
Device Discovery
WS-Discovery enabled:
Simple Network Management Protocol
(SNMP)
SNMP v2c enabled:
Read community:
Write community:
Trap destination 1...4:
Syslog
Server:
Resource Reservation Protocol (RSVP)
RSVP enabled:
Message Interval: