DAILY CHECK (8 HOURS)
Perform Daily Lubrication
Check Hydraulic Reservoir Fluid Level
Fill Fuel Tank
Check Engine Oil Level
Check Coolant Level
Check Hydraulic Cylinder Mounting Bushings
And Pins
Check Hydraulic Components
Check Transmission Oil Level
Check Axle Lockout System
Drain Fuel Filters or Water Separator
Check Boom Front Slider Pads
WEEKLY CHECK (40 HOURS)
Perform The Daily Check
Perform Weekly Lubrication
Check Swing Reducer Oil Level
Perform Initial Axle Oil Change*
Check Axle Oil Level (after initial change)
Check Battery Condition
Check Tire Pressure and Condition
Check Air System Safety Valve
Check Hydraulic Cylinders and Rods
Check Torque on Wheel Lug Nuts
Drain Air Tanks
Check Wire Rope And Related Components
Check Air Cleaner
Check Controls
Check Instruments, Gauges, & Safety Equipment
Make Overall Visual Inspection
Torque Swing Bearing Bolts *
Torque Wheel Nuts First 50 Miles*
Check Anti-Two Block System
Check Engine Manufacturer’s Manual For Addi-
tional Maintenance Requirements
Ensure Swing Brake Is Able To Hold Against Full
Torque of Swing Motor
Make Thorough Inspection Of Wire Rope
Make Initial Replacement Of Hydraulic Return
Line Filter*
Check Alcohol Evaporator Fluid Level
Visually Inspect All Structural Members And
Welds For Cracks, Alignment and Wear
Check Boom For Wear, Cracked Welds, Align-
ment And Missing Or Illegible Decals
Check Engine Manufacturer’s Manual For Addi-
tional Maintenance Requirements
Clean Machine Weekly If Salt Covered To Pre-
vent Rust And Corrosion
Check Torque on Wheel Lug Nuts
MAINTENANCE CHECKS
MACHINE MAINTENANCE
CHECK LIST
* Interval given applies only to initial period of use (break-in).
4 - 3 Revised: November 2005RT700 Series
To Next Page
Loading...
