Lubricate every 100 operating hours as follows:
Inject grease as recommended below through one fit-
ting located beneath an access panel in the operator’s
cab just behind the shift lever, as the machine is rotat-
ed at least two complete revolutions. When complete
rotation is impractical, inject grease through each fit-
ting and rotate machine back and forth as far as possi-
ble as each fitting is greased.
Under extremely dirty or dusty conditions, sufficient
grease should be added to flush out contaminated
grease. Under less severe conditions, add grease until
it appears at the bottom seal.
While swinging the machine, apply gear grease to the
external ring gear with sufficient frequency to insure
that the teeth remain coated.
Some lubricants recommended by the manufacturer
are:
MAINTENANCE AND LUBRICATION
TURNTABLE & SWING PINION
RACE
GEAR
MOBIL
Mobilux
EP1
Mobiltac
375NC
TEXACO
Mutifak
EP1
Crater
2X
SUNOCO
Prestige
742EP
407
Compound B
AMOCO
Amolith
EP1
Amovis
8-X
EXON
Beacon
EP1
Surett
Fluid 4k
NOTE: Other manufacturers’ lubricants of the same quality are suitable.
4 - 17 Revised: March 2005RT700 Series
To Next Page
Loading...
Need help?
General
