WWW.TERRAMITE.COM
Charleston, WV/USA
USA 1.800.428.3772
Intl. 1 .304.776.4231
Read Operators Manual For SafetyPARTS MANUAL
Copyright © 2007 Terramite Corporation
On Hand Spare Parts
Following is a list of spare parts we recommend you keep on hand.
Oil, Fuel and Air Filters
One of each size Cylinder Packing Kit (specify serial number of machine when ordering)
Grease Fittings
One each of a longest length and medium length Hoses and spare Cylinder Fittings
Tie Rod End
Pedal Return Spring
Wheel Bearings
Tooth Caps with Pins
Assortment of long, medium and short Pins
Control Valve Linkage Parts and Cotter Pins
Hydraulic System Oil Change and Type Specifications
When your machine is new, the hydraulic system oil and filter should be changed within the first 50
hours of use and every 250 thereafter. Refill the hydraulic reservoir with engine oil type API SF.CD
15W40 when outside temperature is above 40 degrees F. Use engine oil type API SF.CD 10 weight
when outside temperature is below 40 degrees F. Replace filter with Terramite / 2-200.5C filter or
NAPA / 1759 filter. It is important to follow these instructions to alleviate any cold weather engine
starting problems and any pressure or heat related component failure.
DO NOT USE HYDRAULIC OIL!
MAJOR DAMAGE WILL RESULT!
For your engine oil requirements and change intervals refer to your engine owners manual.
Special Tools
ITEM PART NUMBER DESCRIPTION QTY.
1 10599 1-05.SDT Punch, for 1-05.SD & TT Tooth Caps 1
2 21176 A-176 Spanner wrench for cylinder repair 1
2.55
To Next Page
Loading...