TESTO 300 - E-Mail

13 Using the product
50
13.2.11 E-mail
Setting up an e-mail account
An e-mail account has to be set up in order to be able to send reports
as e-mails. A Wireless LAN connection must be available to set the
account up.
1
Call up function: | E-Mail
2
Enter e-mail address.
3
Enter password.
4
Set account options, such as synchronization interval
5
Entry of account name (optional) and name which appears with the
sent e-mails.

The inbox of the e-mail account is opened.
If the system does not accept the e-mail address and password
combination, but you are certain it is correct, check the following
possible solutions:
• Open e-mail client, e.g. gmail, on a PC and check e-mail reception.
Your provider may have sent you a security e-mail that you need to
acknowledge before the e-mail account can be accepted on the
testo 300 NEXT LEVEL.
• Enable IMAP account
To do this, call up your e-mail account on the PC. You will find the
setting for the common e-mail providers, e.g. gmx, under settings -
POP/IMAP. Account-specific information about the enabling of the
IMAP account is supplied by the relevant provider. Find out about
this from the relevant provider or on the Internet.
• Manual set-up of the e-mail account
1.
Call up function: | E-Mail.
2.
Enter e-mail address.
3.
Select Manual set-up.
4.
Select Private account type (IMAP) (recommended).
5.
Enter password.
6.
Enter/change server, port and security type.
This information is e-mail account specific and is supplied
by your e-mail account provider. Find out about this from
your account provider or on the Internet.