5 First steps
39
5.2.7. Printing / saving data
Assignment of the right function key with the function Save or
Print, see Assigning the right function key page 45 .
Only meas. views, which have a display field in the measurement
view assigned, will be saved / printed out.
The measurement data can be printed out parallel to the
saving process, while a measurement program is running.
To be able to transmit data via infrared or Bluetooth interface to a
protocol printer, the printer to be used must have been enabled,
see Enabling the printer:, page 49.
Graph charts can be printed out using the Bluetooth® /
IRDA printer 0554 0620.
5.2.8. Remembering data (clipboard)
With the help of the clipboard measuring results from various
measurement types can be combined to a common protocol, which
can then be printed out (see above) Data are saved to the
clipboard via the menu Options and the command Clipboard.
If there are data in the clipboard and the command Print is
triggered, all data in the clipboard will be printed out
Only one set of measuring data can be recorded per measurement
type (e.g. Flue Gas or Draft). Repetitive saving of test data of one
measurement type overwrites the previously saved data. When
changing the measurement place or the fuel, the clipboard is
deleted.
> [Options] → Delete clipboard: Any data saved to the
clipboard is deleted.
5.2.9. Confirming an error message
If a failure occurs, an error message is shown in the display.
> Confirming an error message: [OK].
Not yet rectified error messages can be displayed in the menu
Error Diagnosis, see Instrument diagnosis, page 43.
To Next Page
Loading...
