TESTO 330 - Smoke No.; HCT

6 Using the product
62
6.2.6. Smoke No. / HCT
Calling up the function:
> [ ] → Measurements → [OK] → Smokenumber / HCT →
[OK].
The parameters Smoke No. and Oil derivatives are only
available for oil fuels.
Determining smoke tester no. / smoke nos. / oil derivative with
the smoke pump and entering manually:
1. Select parameter → [Edit].
2. Enter data or values → [Next] or [OK].
Determining smoke tester no. / smoke nos. / oil derivative with
the smoke tester testo 308 and transferring wireless:
> [Options] → t308.
- The data recorded by the smoke tester are transferred to the
testo 330.
Entering the heat carrier temperature:
> Heat carrier → [Edit] → Enter value → [OK].
Options:
> [Options] → Clipboard: Data are saved to the clipboard:
> [Options] → Delete clipboard: Any data saved to the clipboard
is deleted.
> [Options] → Save: The meas. views are saved in a protocol.
> [Options] → Reset values: The entered data are deleted.