TESTO 330 - Transferring Data

6 Using the product
73
6.3. Transferring data
6.3.1. Protocol printer
To be able to transmit data via infrared or Bluetooth interface to a
Testo protocol printer, the printer to be used must have been
enabled, see Printer, page 49.
Representation of the available characters per line is limited on the
printout. Thus, the unit mg/KWh is displayed on the printout as
mg/k.
6.3.2. PC / Pocket PC
Data transfer to a PC can take place via USB, IrDA or Bluetooth
®
.
You must also refer to the documentation that comes with the
software.