TESTO 330 - Programs

6 Using the product
54
Enabling fuels:
> Select the fuel → [OK].
- The fuel is enabled and the main menu is opened.
Setting coefficients:
1. Select the fuel → [Coeff.].
2. Select the coefficients: [Edit].
Possibly:
> Enter the password: [Enter] → Enter password → [Next] →
[OK].
3. Set data → [OK].
4. Save changes: [Finished].
Setting set limits:
1. Select set limit → [Edit].
2. Set data → [OK].
3. Save changes: [Finished].
6.1.5. Programs
Five measuring programs for different measurement types can be
configured and enabled. The measuring programs serve the
purpose of saving and representing measuring sequences. After
the end of the measuring process the meas. views of a measuring
program are automatically saved in a protocol.
Only one measuring program can be enabled in the instrument.
Calling up the function:
Enabling / disabling a program:
> Select the program: [▲], [▼] → [Enable] or [Disable].
- When enabling a program: The program is enabled and the
measurement type matching the program is opened.
Configuring the program:
The measuring cycle takes 1s and cannot be changed.
An enabled program cannot be configured.
1. Select the program: [▲], [▼] → [Edit].
2. Select parameters program name, measurement type, gas
phase: [▲], [▼] → [Edit].
3. Set parameters or enter data: [▲], [▼] and partly [◄], [►] →
[OK].
4. Save changes: [Finished].