TESTO 330 - Alarm Thresholds; Units

6 Using the product
47
Options:
> [Options] → Number of Lines: Change the number of
measuring values per display page.
> [Options] → Insert Blank Lines: Insert the blank line before
the selected line.
> [Options] → Delete Line: Delete the selected line.
> [Options] → Factory Setting: Reset the measurement view to
factory setting
6.1.2.2. Alarm thresholds
Alarm thresholds can be set for several display parameters. An
audible alarm signal is triggered when the alarm limit is reached.
Calling up the function:
Switching alarm signals on / off, changing alarm thresholds:
1. Select function or data: [▲], [▼] → [Edit].
2. Set parameter: [▲], [▼] and partly [◄], [►] → [OK].
3. Save changes: [Finished].
> Reset the enabled value to the factory setting: [Standard].
6.1.2.3. Units
The units used for parameters in configuration menus can be set.
Calling up the function:
Adjustable units
Parameter
Unit
Altitude m, ft
Pressure mbar, hPa
1. Select the line: [▲], [▼] → [Edit].
2. Select the unit to be edited: [▲], [▼] → [OK].
3. Confirm the entry: [Finished].