TESTO 330 - Password Protection; Sensor Settings

6 Using the product
51
6.1.2.12. Password protection
Password protection can be enabled / disabled, the password can
be changed.
To disable the password protection change the password to 0000
(factory setting).
Calling up the function:
Possibly:
> Enter the currently valid password:
[Enter] → Enter password → [Next] → [OK].
Changing the password:
1. [Edit].
2. Enter the new password → [Next].
3. [Edit].
4. Enter the new password again to confirm → [Next].
5. Save changes: [Finished].
6.1.3. Sensor settings
6.1.3.1. NO
2
addition
The NO2 addition parameter can be set.
The preferences of the NO2-addition can be password protected,
see Password protection, page 51.
Calling up the function:
Possibly:
> Enter the password: [Enter] → Enter password → [Next] →
[OK].
Setting the NO
2
addition:
> Set parameter → [OK].