6 Using the product
59
Show flue gas matrix
This function is only available if the measurement parameter CO
has been enabled in the meas. view display.
Calling up the function:
✓ The flue gas function is opened.
> [Options] → Flue Gas Matrix:
Options
> [Options] → Clipboard: Data are saved to the clipboard:
> [Options] → Delete clipboard: Any data saved to the clipboard
is deleted.
> [Options] → Save: The meas. views are saved in a record.
> [Options] → Show Graphic: The meas. views are displayed in
form of a line graph.
> [Options] → Show Numerical Values: Data are displayed as
numerical values.
> [Options] → System Type: (This function is not available
during a measurement) Set the system type to be able to
configure the ideal array (green) of the flue gas matrix, using
the limits pre-configured for each system type.
> [Options] → Reset Graphic: The displayed graphical data are
deleted.
> [Options] → Limits: (This function is not available during a
measurement) Enter limits to be able to configure the ideal
array (green) of the flue gas matrix.
> [Options] → CO + O2 or CO + CO2: Choose which
measurement parameter should be assigned to the x-axis of the
display matrix (O2 or CO2).
> [Options] → Measurement vew: (This function is not available
during a measurement) Open the mesurement view menu.
3.
To Next Page
Loading...
