CC1101
SWRS061H Page 97 of 98
33 General Information
33.1 Document History
Added 256 Hz clock to Table 41: GDOx Signal Selection
Crystal NX3225GA added to application circuit BOM
Added reference to CC1190 range extender
Added reference to AN094 and AN096
Corrected settling times and PLL turn-on/hop time in Table 15
Added reference to design notes DN032 and DN036
Removed references to AN001 and AN050
Changed description of MCSM0.PO_TIMEOUT
Removed link to DN009
Added more detailed information about how to check for PLL lock in Section 22.1
Changed from multi-layer to wire-wound inductors in Table 38.
Included PA_PD and LNA_PD GDO signals Table 41 as they were erroneously
removed in SWRS061E.
Updated WOR current consumption figures in Table 4.
The Gaussian filter BT is changed from 1.0 to 0.5.
Changed minimum data rate to 0.6 kBaud.
Updated Table 25 with 0.6 kBaud data rate.
Added information that digital signals with sharp edges should not be routed close to
XOSC_Q1 PCB track.
Added information about 1/XOSC glitch in received data output when using
asynchronous serial mode
Added information that a 27 MHz crystal is recommended for systems targeting
compliance with modulation bandwidth requirements in the 869 to 870 MHz frequency
range under EN 300 220.
Updated overall state transition times in Table 34 and added table with frequency
synthesizer calibration times (Table 35).
Added -116 dBm 1% PER at 0.6 kBaud, 434 MHz
Included information about 4-FSK modulation
Added sensitivity figures for 4-FSK
Added link to DN507
Updated PKTSTATUS.SFD. In TX this bit reads as 0.
Updated PKTSTATUS.PQT_REACHED.
Removed chapter on Packet Description
Changed chapter on Ordering Information since this was duplicate information.
Maximum output power increased to +12/+11 dBm at 868/915MHz with the use of
wire-wound inductors (Murata LQW15xx series).
Changes to optimum PATABLE settings.
Added typical output power over temperature and supply voltage.
Changes to current consumption in TX mode.
Added typical TX current consumption over temperature and supply voltage.
Improved sensitivity figures at 868/915 MHz.
Added typical sensitivity figures over temperature and supply voltage.
Added typical RX current consumption over temperature and input power level.
Changes to adjacent channel rejection at 38.4 kBaud.
Changes to image rejection at 250 kBaud.
Updates to selectivity/blocking plots.
Changed bill of materials for 868/915 MHz application circuits to Murata LQW15xx
series inductors.
Changed analog temperature sensor temperature coefficient.
Added links to DN501 and DN504
Changes to section 17.6. A low LQI value indicates a good link
Changes to Package Description section
Changes to Ordering Information section
To Next Page
Loading...
Need help?
General
