3.4 EVM DIP Switches
J721E EVM supports User DIP Switches for EVM Configuration and SoC Boot mode set function.
3.4.1 EVM Configuration DIP Switch
Figure 3-6 shows that the common processor board has a dedicated EVM configuration switch (SW3) to set
the various functions of EVM peripherals. Some of the configuration is for peripherals on the CPB, while
others switches are used to configure peripherals on Expansion Boards. For those settings, the device-specific
Expansion Board User's Guide will define the switch function.
Figure 3-6. EVM Configuration DIP Switch
EVM User Setup/Configuration www.ti.com
18 Jacinto7 J721E/DRA829/TDA4VM Evaluation Module (EVM) SPRUIS4D – MAY 2020 – REVISED MARCH 2022
Submit Document Feedback
Copyright © 2022 Texas Instruments Incorporated
To Next Page
Loading...
