Connectivity 119
Common Error and Notification Messages
Shown on: Message and Description:
Sending unit
This is displayed after several seconds if:
• A cable is not attached to the sending unit’s
link port.
– or –
• A receiving unit is not attached to the other
end of the cable.
– or –
• The receiving unit is not set up to receive.
Press N or ¸ to cancel the transmission.
Note: The sending unit may not always display this
message. Instead, it may remain BUSY until you
cancel the transmission.
Sending unit
The receiving unit does not have the correct
certification for the operating system (OS) or Flash
application being sent.
To Next Page
Loading...
Need help?
General
