Texecom Premier 816 - Keypad Speaker Output (LCDL;LCDLP FMK;SMK); Adjustable Backlighting; Keypad Lid Tamper; Remote Zone Expander Module

Premier 412/816/832 Installation Manual Installation
INS159-13 13
Keypad Speaker Output (LCDL/LCDLP
FMK/SMK)
The Premier LCDL and LCDLP keypads has an output that can be
used for driving up to one 8 or two 16 loudspeakers (see page
18 for wiring details).

The speaker volume is also fully adjustable (see page 36 for
details).
Adjustable Backlighting
To adjust the keypad backlighting press the YES key, then with the
YES key still pressed use  to increase or decrease the
backlighting until the required brightness is achieved, then release
both keys.

The backlight can only be adjusted when the keypad is not
in a menu.
Keypad Lid Tamper
The lid tamper of each keypad can be disabled if required using the
relevant keypad option in the Keypad Options 4 menu (see page 43
for details).
Remote Zone Expander Module
The Premier 8X Remote Zone Expander provides 8 additional
detection zones, two programmable outputs and a speaker driver
output.
Remote Expander Layout

Data Bus Connections

Programmable Zone Inputs

Auxiliary 12V

Programmable Outputs 1 and 2

Speaker Driver Output

Power LED

Disable Tamper Jumper

Tamper Switch

Address DIL Switch
Wiring the Zone Expander
The Remote Zone Expansion Module is connected to the data bus
terminals located at the bottom left hand side of the PCB. (See
pages 8 to 10).
Remote Expander Address
Each remote expander must be assigned a different address using
the Address DIL switch (

). The table below shows how to set the
address:
Address
DIL 1
DIL 2
DIL 3
DIL 4
1
On/Off
Off
Off
Off
2
Off
On
Off
Off
3
Off
Off
On
Off

Only one remote expander can be connected to the Premier
412 & 816 control panels (Address = 1).
Remote Expander Zones
The Premier 8X Remote Expander has eight programmable zone
inputs (see page 15 for wiring details). Each zone is also fully
programmable (see page 25 for programming details).
The table below shows the system zone allocation when one or
more modules are installed:
Address
Remote Expander Zone Inputs
Z1
Z2
Z3
Z4
Z5
Z6
Z7
Z8
1
09
10
11
12
13
14
15
16
2
17
18
19
20
21
22
23
24
3
25
26
27
28
29
30
31
32

When the system is expanded above 8 zones, it MUST be
fitted with a suitable remote keypad. For systems up to 16
zones a Premier RKP16 or Premier RKP16 Plus should be
installed. For systems above 16 zones a LCD remote keypad
should be installed.
The system will only support one type of expansion device
for zones 09 - 16, i.e., you can fit either a Premier 8X Remote
Expander (Address = 1) or a Premier 8XE Local Expander,
you cannot fit both.