Texecom Premier 816 - Operating the Alarm System; Basic Operation and Arming

System Overview Premier 412/816/832 Installation Manual
6 INS159-13
 Fully adjustable back-lighting, normally bright, dim or
off, changing to bright whenever a keypad is used and
during the entry mode
 Dedicated status lights for “Alarm”, “Service”, “Armed”,
“Ready”, “Fire”, “Bypass”, “Instant” and “Stay”
Premier LCD & LCDL
The Premier LCD remote keypad has a standard 32 character back-
lit LCD display, whereas the Premier LCDL has a large 32 character
back-lit LCD display.
 2 programmable EOL zones
 1 programmable low current (100mA) output
 4-wire connection to data network.
 Built in piezoelectric sounder.
 Fully adjustable back-lighting, normally bright, dim or
off, changing to bright whenever a keypad is used and
during the entry mode
 Dedicated status lights for “Power”, “Armed”, “Ready”,
“Service” and “Bypass”
 Speaker driver output (Premier LCDL Only).
Premier LCDLP
 Premier LCDL keypad with built-in proximity tag reader
Premier LCDP
 Premier LCD keypad with built-in proximity tag reader
Premier Elite FMK
 Flush Mount LCDLP with built in proximity tag reader
iconic keys.
 Available in various finishes
Premier Elite SMK
 Flush Mount LCDLP with built in proximity tag reader
iconic keys.
 Available in various finishes
Zone Expansion Modules
Either system can be expanded using one of the following zone
expansion modules:
Premier 8X Remote Zone Expander
This module comes supplied in its own enclosure and is connected
to the control panel data network to provide remote expansion of
the system. This module provides the following additional facilities:
 8 programmable EOL zones
 2 programmable low current (100mA) outputs
 Speaker driver output with electronic volume control.
Premier 8XE Local Zone Expander
This module comes supplied as a PCB and simply plugs onto the
main control panel circuit board. This module provides 8
programmable EOL zones.
PC-Com Module
This module plugs on to the Premier 412, 816 and Premier 832
control panel to provide an RS232 interface, which can be used for:
 Connection of a serial printer to print the event log
 Upload/download the system programming via Wintex
UDL software and PC.
ComIP Module
This module plugs on to Com1 or Com2 of the control panel to
provide the following:
 Alarm event reporting via TCP/IP (WAN/LAN).
 High speed upload/download of system programming
via WAN/LAN using Wintex UDL software.
Speech Module
This module plugs on to the control panel to provide the following:
 4 recordable messages (12 seconds each).
 Each message can be assigned to a specific output
function, e.g. Alarm or Fire.
This manual does not cover the full installation of this device; please
refer to the instructions supplied with the Speech Module.
Radio Receiver Module
The control panel will accept either the Texecom Ricochet™ Premier
Elite 8XP-W or Premier Elite 32XP-W. The receiver module should
be wired to the control panel network to provide the following:
 32 wireless devices, such as PIR, Door Contacts, Shock
Sensors, Remote FOBs etc.
 Ricochet™ Mesh Networking Technology
 RF supervision of each device.
 Battery supervision of each device.
This manual does not cover the full installation of these devices;
please refer to the instructions supplied with the radio receiver
module.