Texecom Premier 816 - Zone Alarm;Restore Codes; Zone Bypass;Unbypass Codes; Non Zone Alarm;Restore Codes; Contact ID and SIA Codes

Premier 412/816/832 Installation Manual Programming the Control Panel
INS159-13 63
Zone Alarm/Restore Codes 
This menu option allows you to change the alarm/restore reporting
event codes for each zone. These codes are used with Pulse
Format, Express Format, Pager and Mobile Phone communication
protocols. The default reporting codes are listed in the
programming worksheets from page 86.

To disable the zone from reporting an event, program the
first and second digit as 00.
Zone Bypass/Unbypass Codes 
This menu option allows you to change the bypass/unbypass
reporting event codes for each zone. These codes are used with
Pulse Format, Express Format, Pager and Mobile Phone
communication protocols. The default reporting codes are listed in
the programming worksheets from page 86.

To disable the zone from reporting an event, program the
first and second digit as 00.
Non Zone Alarm/Restore Codes 
This menu option allows you to change the reporting event codes
for non zone events. These codes are used with Pulse Format,
Express Format, Pager and Mobile Phone communication
protocols. The default reporting codes are listed in the
programming worksheets from page 86.

To disable the event from reporting, program the first and
second digit as 00.
The table below shows the event numbers for both alarm and
restore for each event type:
Event Type
Alarm
Event No
Restore
Event No
AC Fail
00
01
Low Battery
02
03
Telephone Line Fault
04
05
Fail to Communicate
06
07
Open/Close
08
09
Recent Closing
10
11
Auto Open/Close
12
13
Auto Arm Deferred
14
15
Remote Open/Close
16
17
Quick Arm
18
19
Open After Alarm (Cancel)
20
21
Download Start
22
23
Download End
24
25
Group Bypass/Unbypass
26
27
Log Capacity Alert (80%)
28
29
Keypad Lockout
30
31
Code Tamper Alarm
32
33
Event Type
Alarm
Event No
Restore
Event No
Manual Test Transmission
34
35
Automatic Test Transmission
36
37
User Zone Test Start/End
38
39
Auxiliary Power Fail/Restore
40
41
Bell Output Fault/Restore
42
43
Installer Programming Start
44
45
Installer Programming End
46
47
Exit Error
48
49
Verified Cross Zone Alarm
50
51
Soak Test
52
53
Fire Zone Trouble
54
55
System Power Up
56
57
Swinger Shutdown
58
59
User Code
60
61
Exit Started
62
63
Entry Started
64
65
Bell Active
66
67
Alarm Active
68
69
Keypad Tamper
70
71
Keypad Medical
72
73
Keypad Fire/2-Wire Smoke
74
75
Duress Code Alarm
76
77
Keypad Silent PA
78
79
Keypad Audible PA/Auxiliary PA
80
81
Box Tamper
82
83
Zone Tamper
84
85
Zone Trouble
86
87
Expander/Remote Trouble
88
89
Auxiliary Tamper Input
90
91
Date Changed
92
93
Time Changed
94
95
System Reset
96
97
Remote Control
98
99
Contact ID and SIA Codes
The reporting codes for Contact ID and SIA are fully configurable,
however these codes can only be changed using Wintex
downloading software.