Premier 412/816/832 Installation Manual Programming the Control Panel
INS159-13 61
IP Address & Port -
This option allows you to assign a local IP address and port number
to a module connected to a Com Port (e.g. ComIP or Chiron IRIS).
The IP address and port number MUST be entered as a 17 digit
sequence, e.g. If the IP address is 192.168.0.10 and the port
number 980, then it should be entered as: 19216800001000980. If
an IP module (WebWayOne, Chiron IRIS, etc) is fitted its IP address
and port must also enter via the Polling IP address and port
number.
Note for the Chiron IRIS module entry of only the12 digit
IP Address results in the port number being set to its
default, 10001.
ComIP Gateway Address -
This option allows you to assign a Gateway IP address to the ComIP
module (if fitted). The Gateway IP address MUST be entered as a 12
digit sequence, e.g. If the Gateway IP address is 192.168.0.1, then it
should be entered as: 192168000001.
ComIP Subnet Mask -
This option allows you to assign a Subnet Mask to the ComIP
module (if fitted). The Subnet Mask is entered as a decimal value of
001 through to 024. Each decimal value generates the following
Subnet Masks used by the ComIP module:
Com2 Device Type -
This option allows you to specify which module is connected to
communication port Com2. See Com1 Device Type above for a list
of supported devices.
Chiron Iris Data Setup -
This menu option has three submenus to allow programming of the
Chiron Iris module data. The value of each parameter can be viewed
by pressing the key or its value can be edited by pressing the
key. A maximum of 30 characters for the Access Point Name
and 32 Characters for User Name and Password can be entered.
Text is programmed in a similar way to mobile phones. Characters
are selected by pressing the corresponding key the appropriate
number of times (to select a character on the same key, press the
key to move the cursor along). For details on entering text, see
page 22.
--
Access Point Name
This is the GPRS Access Point Name. It’s value can be viewed by
pressing the y key or its value can be edited by pressing the
n key. A maximum of 30 characters can be entered. Text is
programmed in a similar way to mobile phones. Characters are
selected by pressing the corresponding key the appropriate number
of times (to select a character on the same key, press the key
to move the cursor along). For details on entering text, see page 22.
--
User Name
This is the GPRS Access Point Name. It’s value can be viewed by
pressing the key or its value can be edited by pressing the
key. A maximum of 32 characters can be entered. Text is
programmed in a similar way to mobile phones. Characters are
selected by pressing the corresponding key the appropriate number
of times (to select a character on the same key, press the key
to move the cursor along). For details on entering text, see page 22.
--
Password
This is the GPRS Access Point Name. It’s value can be viewed by
pressing the key or its value can be edited by pressing the
key. A maximum of 32 characters can be entered. Text is
programmed in a similar way to mobile phones. Characters are
selected by pressing the corresponding key the appropriate number
of times (to select a character on the same key, press the key
to move the cursor along). For details on entering text, see page 22.
To Next Page
Loading...
