Expander Partitions
When the expander is assigned to one or more partitions the
speaker output on the expander will generate tones only for the
partition(s) it’s assigned to. E.g. if the expander is assigned to
partition 3, the speaker will only be enabled when partition 3 is in
alarm, entry, exit etc.
Expander Tones
The Expander Tones are described as follows:
Fire Alarm Tones from Expander
On: The siren output on the Expander will produce Fire Alarm
tones.
Off: Fire Alarm tones will not be produced.
Burglary Alarm Tones from Expander
On: The siren output on the Expander will produce Burglary Alarm
tones.
Off: Burglary Alarm tones will not be produced.
Service Tones from Expander
On: The siren output on the Expander will produce Service tones.
Off: Service tones will not be produced.
Acceptance Tones from Expander
On: The siren output on the Expander will produce Acceptance
tones.
Off: Acceptance tones will not be produced.
Error Tones from Expander
On: The siren output on the Expander will produce Error tones.
Off: Error tones will not be produced.
Chime Tones from Expander
On: The siren output on the Expander will produce Chime tones.
Off: Chime tones will not be produced.
Exit Tones from Expander
On: The siren output on the Expander will produce Exit tones.
Off: Exit tones will not be produced.
Entry Tones from Expander
On: The siren output on the Expander will produce Entry tones.
Off: Entry tones will not be produced.
Expander Volume Level
This option controls the advisory tones (entry/exit, fault etc.) volume
level of the speakers connected to the remote expander speaker
output. 0 = minimum volume; 7 = maximum volume.
To Next Page
Loading...
