Partition Exit Delay
This timer controls the delay between the user initiating the exit
procedure for the selected partition and the partition actually
arming. If a ‘Push to Set” zone is used for arming the partition, this
timer must be set to 255 seconds.
Partition Entry Delay 1
If the user enters the premises via a ‘Delay 1’ zone, the system uses
this timer to allow the user time to access the keypad and disarm
the selected partition.
The Entry Delay Timer must be set at 30 seconds or
greater to comply with the requirements of EN50131.
Partition Entry Delay 2
If the user enters the premises via a ‘Delay 2’ zone, the system uses
this timer to allow the user time to access the keypad and disarm
the selected partition.
The Entry Delay Timer must be set at 30 seconds or
greater to comply with the requirements of EN50131.
Partition Communication Delay
This timer controls the delay between an alarm occurring in the
selected partition and the panel reporting the alarm event to the
alarm receiving centre.
Partition Bell Delay
This timer controls the delay between an alarm occurring in the
selected partition and the bell output activating.
Partition Bell Duration
This timer controls the duration of the bell output after an alarm has
occurred in the selected partition.
Partition Options
The function of the partition options is described as follows:
Enable Auto Bypass Mode
On: The system will automatically Stay arm the selected partition if
the user arms the system using the ARM button, but does not
violate the entry/exit zone.
Off: The system will away arm the selected partition even if the
entry/exit zone is not violated.
Stay Armed Exit is Silent
On: The selected partition will not generate an exit tone when
being Stay armed.
Off: The selected partition will generate exit tone.
Enable Remote Arming
On: The selected partition can be armed remotely via download
software.
Off: The selected partition cannot be armed remotely.
To Next Page
Loading...
