NBC™ Flat Belt - IOM
P/N: 1118140 Rev: 07/29/2020 Page 29 of 129
GEAR MOTOR ACTIVATION
PRIOR to systems activiation - Please inspect the gear unit for a vent and if applicable to the product
remove the rubber sealing plug to activate. The vent is designed to allow excessive pressure to
escape. Each gear unit should have a yellow instruction tag as shown below. The tag can be removed
after the plug is removed.
NOTE: The rubber sealing plug is in place for shipping and storage purpose only.
In order for the gear motor to release pressure, the vent must be activated
by removing the rubber sealing plug PRIOR to gear unit start up.
Please check you gear unit for a vent and if applicable to your product, remove the sealing
plug to activate. “https://www5.nord.com” Operation Manual for Gear Units (B1000).
To Next Page
Loading...
