NBC™ Flat Belt - IOM
P/N: 1118140 Rev: 07/29/2020 Page 38 of 129
1.17: THREADING BELT IN NBC TRANSPORTATION CONVEYOR
Step 1
NBC transportation conveyor is spring to drive with no air. To open a belt path, two Cams under each
pressure pan must be rotated to the high side of the Cam.
Step 2
Thread the belt as shown in steps 3 through 8 of the NBC accumulation conveyor.
Step 3
Rotate each Cam back to the low side of the Cam re-engaging the spring.
Form more NBC applications TGW recommends the following IOM’s at
https://www.tgw-
conveyor.com/technologies/belt-driven-roller-conveyor/nbc-manual
TGW Also recommends NBC maintenance videos for tracking the NBC belt and NBC belt alignment
at https://www.tgw-conveyor.com/media-center/maintenance-videos/82-belt-driven-live-roller
3/4” socket
Rotate to high
side of Cam
Rotate back to low
side of Cam
To Next Page
Loading...
