NBC™ Flat Belt - IOM
P/N: 1118140 Rev: 07/29/2020 Page 57 of 129
CRUZcontrol Logic Module Concepts
The CRUZcontrol product line is a set of off the shelf components used to setup accumulation and
discharge on NBC conveyor. It consists of logic modules that detect product which control
accumulation, function modules that release product, and 24 VDC power supplies. There are also
accessories such as sensors and cables to ease installation and interfacing.
CRUZcontrol is a 24 VDC system that will automatically start accumulation when product reaches the
end of an accumulation line. When a release signal is applied to a function module that is installed at
the discharge end of an accumulation line, the product will begin to release. Product will continue to
release until the signal is removed. The type of accumulation that occurs is based on the mode that
the logic assembly has been configured for. The type of product release is based on logic assembly
mode and function module setup.
Figure 1: Basic Concept Layout
To Next Page
Loading...
