iCNC PERFORMANCE
5-44 NESTING Manual 0-5399
Feed rate codes
• No Rapid feed rate If this option is set, then feed rates are not saved for rapid speed.
• Feed rates at the end of line/on separate line Feed rates can be saved on their own lines or at the end of a code line. This option
determines which way is used. See examples below.
Example 1 (at the end of line):
G01 X10 Y10 F200
Example 2 (on separate line):
F200
G01 X10 Y10
Codes
Rapid move, Linear cut, Arc CW and Arc CCW set the codes, which are used when saving EIA files. If Null G is linear is selected, then
there will be no code before rapid movement or linear cut.
Load & Save As...
If you need to save different EIA files from different sources which use various types of EIA, it is useful to save the settings for each
EIA type separately. Save the settings by choosing Save as and load them back by choosing Load.
See also EIA Programming.
www.TechnicalBooksPDF.com
To Next Page
