Thermo Scientific 310 - Section 1 Installation and Start-Up

Model 310 Series DH Incubator 1-1Thermo Scientific
Section 1 Installation and Start-Up
Incubator components are described below.
Figure 1-1. Model 310 Series Direct Heat Incubator
• Outer Door - Reversible to opposite swing, see Section 5
• Inner Door - Reversible to opposite swing, see Section 5
• Chamber Gas Sample Port - Used for sampling chamber CO
2 content
using a FYRITE or similar instrument.
• Main Power Switch
• Control Panel - Keypad, Displays and indicators (See Figure 1-2)
• Leveling Legs - Used to level the unit
Note The incubators are stackable. Information follows.
s